10-30-2002 08:20 AM - edited 03-12-2019 09:21 PM
i had tested the OSP with C2610 and C3640.
it had been OK.
but with c3640 and AS5350 or c2610 and AS5350 is not.
when i dial from c3640 to AS5350, the AS5350 gave me the validate fails message for token(by debugging - Signature not verified) on AS5350.
i could not understand why AS5350 can't validate the token which had worked well between c2620 and c3640.
and surely the configuration is almost same with as5350 and c3640 and c2610.
i could not figure it out.
plz, help me
11-05-2002 08:32 AM
Hope you are using the right image on the 5350. Note that few feature set do not support OSP.
You can take a look at this table to verify if your image supports OSP
http://www.cisco.com/en/US/products/hw/univgate/ps505/prod_release_note09186a00800b4298.html#65301
11-05-2002 08:37 AM
thank your reply.
but,i had upgraded it from c5350-ik8s-mz.122-2.XB6.bin to c5350-ik8s-mz.122-2.XA.bin.
surely same problem on c5350-ik8s-mz.122-2.XA.bin
11-13-2002 07:04 PM
i figured it out.
different IOS version(12.1 and 12.2) was that reason.
AS5350 was 12.2.11T, C3640 or C2610 were 12.1.3T.
when i had upgraded the IOS of c2610 or c3640, from 12.1.3T to 12.2.11T
the problem was gone away.
thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide