In documentation I read the author say the Auto QoS feature enable LLQ in core and distribution switchs as a queing method and WRR (Weight Round-Robin) or PQ (Priority Queuing) in LAN access switch. I known Auto QoS feature follow Cisco recommandation about QoS implementation, but I would like understanding why Cisco does'nt recommand LLQ also in LAN access switches rather than WRR or PQ ?
I did not find anything says LLQ can be use CoS marking to know in which queue trafic should assign, but I did not find anymore about WRR and PQ about CoS marking for classification of the network trafic.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...