Within a dial-peer, is there a way to have 'any number of digits' matched after a specific pattern is there. I know within the call manager you can do this but I have not seen this done within the 3640 router. I wish to have any calls (which could have 3-10 digits after it) which start with an access code of 22 pass out this one FXO link. The only way I can see currently is to have 7 dial-peers. I would like these to all fall under one if possible.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.