I was reading the CM 4.1 Admin Guide last night and I saw that wildcards can be used in directory numbers. That's pretty cool, but when would you ever have a use for that? What are some uses for wildcards in DNs?
I can think for example, a number 1XXX, when users dial a extension that is not configured in that range (ie 1097), based on CCM Digit Anlisys rules, match the pattern and ring the secondary line for the operator configured as 1XXX, based on longest-match.
I also have seen this with dummy phones for Direct Transfer to VM.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...