When doing voice you also need the voice network module with the dsp's in it. The part for t1 pri is nm-hdv-1t1-24 or nmhdv-2t1-48. The part for E1 pri is nm-hdv-1e1-30 and nm-hdv-2e1-60. The first one of each of these is 1 t1/e1 and the second support 2 t1s/e1s.
Thanks for your information. But I am planning to use only for data , Where remote location with BRI will dial on PRI interface in centre location (2610 router with PRI interface) .In this case which PRI card i should buy to meet my requirements.
2) Do I need to buy different PRI /BRI interface if am using it for Tokyo if so what is the part number ?
3) What if want to use for Korea with PRI and BRI interface does it require different card.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...