Will VoIP over BRI in backup mode work when the T1 fails?
Scenario: (2) 3640's each with (1)T1 to PBX for VoIP ( 8 channels of T1 using G.729). The 3640's are connected on the WAN using a Single T1 using either PPP or Frame. A single BRI is used for dial back. Question: Will VoIP over BRI in backup mode work. Will at least a few voice calls work?
Re: Will VoIP over BRI in backup mode work when the T1 fails?
Yes a few calls would work but you have to ensure the right QOS is in place. LLq and LFI. Also under the voip dial-peer, you might want to limit the number of acceptable calls so that we dont oversubscribe the isdn 128kb link.
g729 = 26Kb/s for one voice call with no crtp
i.e you can only have 75% of 128/26 calls for good quality to
be achived =3 calls.
If doing crtp then one voice call now uses 12KB/s and you can have
The command to use to limit accepted call under dial-peer
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...