I'm trying to configure a WS-X4604-GWY w/ VWIC-1MFT-T1 for an E&M wink trunk. The issue is that the "operation 4-wire" command is missing and the default is 2-wire. Is 4-wire note supported in 12.1(5)YF2? TAC had me go to this load to get the 8port FXS & DSPs working. Thanks.
Given how this equipment should work, I'd agree with you. When I do a show voice port 1/0:1 it states that the controller is operating as E&M type 1 two-wire. I have an existing Lucent PBX on this trunk set for ESF B8ZS 4-Wire E&M wink and it is running fine. I know the circuit is good. Any other thoughts on this? Thanks.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...