cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
206
Views
0
Helpful
2
Replies

WS-X4604-GWY, IOS 12.1, + E&M Wink 4-wire

jhatfield
Level 1
Level 1

I'm trying to configure a WS-X4604-GWY w/ VWIC-1MFT-T1 for an E&M wink trunk. The issue is that the "operation 4-wire" command is missing and the default is 2-wire. Is 4-wire note supported in 12.1(5)YF2? TAC had me go to this load to get the 8port FXS & DSPs working. Thanks.

2 Replies 2

mimckee
Level 1
Level 1

You should not have to define operation 4-wire if you are using the t1 port. T1 only use 4 wires. You should just need the ds0-group under the controller to get the voice port and that should be fine.

Thank you,

Given how this equipment should work, I'd agree with you. When I do a show voice port 1/0:1 it states that the controller is operating as E&M type 1 two-wire. I have an existing Lucent PBX on this trunk set for ESF B8ZS 4-Wire E&M wink and it is running fine. I know the circuit is good. Any other thoughts on this? Thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: