Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-X6608-T1 used as PRI, what is equivalent HW in 3745?

I'm looking for an NM module for a 3745 that would provide failover for a WS-X6608-T1 being used as a PRI gateway in CallManager. Any Ideas?

4 REPLIES
New Member

Re: WS-X6608-T1 used as PRI, what is equivalent HW in 3745?

The NM-HDV-1T1-24 or NM-HDV-2T1-48 is real nice and affordable. If this is for a remote WAN site I like to buy the 2 port NM even though I only end up using 1 PRI port. I then use the second port for a DSP resource to handle HW conferencing/XCoding locally.

http://www.cisco.com/en/US/partner/products/hw/routers/ps282/prod_models_comparison.html

Thanks

Mike

New Member

Re: WS-X6608-T1 used as PRI, what is equivalent HW in 3745?

Is the NM-2CT1 just a stripped down version, or for a completely different application?

Re: WS-X6608-T1 used as PRI, what is equivalent HW in 3745?

Completely different.

NM = Network Module

HDV= High Density Voice

C= channelised

The NM-2CT1 is a data only application interface.

If it hasn't got a V in it then it doesn't do voice.

Paul

New Member

Re: WS-X6608-T1 used as PRI, what is equivalent HW in 3745?

Thanks a lot for the feedback, I was looking at the NM-HDV-1T1-24, but wanted to make sure it wasn't overkill. Thanks again

91
Views
0
Helpful
4
Replies
CreatePlease to create content