Just building some 5548UP's with N2K-C2248TP-E-1GE Fex's and we're using Cisco Twinax cables to connect between the 5K's and 2K's (part number SFP-10G-AOC2M).
All interfaces are up and seem to be working ok, no errors etc. But when we do a show int status the SFP's are showing as type unknown.
Is this an issue.?
Ethernet1/11 transceiver is present type is 10Gbase-(unknown) name is CISCO-AVAGO part number is AFBR-7CER02Z-CS1 revision is B1 serial number is AVE1742K01J-A nominal bitrate is 10300 MBit/sec Link length supported for copper is 2 m cisco id is -- cisco extended id number is 4
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...
RBAC users like email@example.com may fail HX Connect login. At that time, "Incorrect user name or password(100005)" is shown as a failure reason.
RBAC users can login to vCenter server. So, RBAC username and passwo...