In our enviroment we have two Nexus 5548UP and an HP Enclosure with the HP 10GbE Pass-Thru Module (16 ports). I have red that these devices are passive and are able to cross the FCoE traffic. Now, the question is:
If I have to install Virtual Center (For VMware) on a blade for example... Have I to configure the ports (with FCoE) on the 5548 that will be connected to a (or more) port of the PassTrough? The Ethernet traffic and the San traffic will cross trough the HP 10GbE Pass-Thru Module and then through the 5548UP ?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...