Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

debug output issue on Nexus 7K

Hi,

I am ruuning ospf between two vlans through firewal on Nexus 7000, and it has stuck in EXSTART state.MTU is same on both VLANS.I also has configured mtu-ignore command .When I am running debug (debug ip packet and the debug ip ospf adj) on, I cant see any out put to my screen.I have confiure "term mon"as well.

Is there is any other command on Nexus to see debug of these above command?

Regards,

1 REPLY
Cisco Employee

Re: debug output issue on Nexus 7K

Hello Mohammed

You can use ethanalyzer to capture traffic towards the CPU.

1317
Views
0
Helpful
1
Replies