I have not been able to find any information regarding this post. I am guessing it is pobrably because it can not be done. We are upgrading to a 208 V instead of 120 V. Is this an option when swapping power supplies(PS)? In short, is it possible to have 1 out of three PS be of a different V and Amp?
We tried it on a test chasis. It does work. I wouln't expect anything less from Cisco. To upgrade to a higher power supply hot swap works the same. Actually the switch can operate with power supplies of different wattage.
Moquery is the command line cousin of Vizore, it's very helpful and efficient sometimes during the troubleshooting. This article aims to provide moquery cheat sheet to the users for some most common seen scenarios.
Here is the checklist before customers/partners contact Cisco TAC:
Firmware Version of APIC and Switch
Download Switch and APIC techsupport logs
Problem description (Symptoms with details)
Business impact (eg, what kind of services...
moquery usageAPIC moquerySwitchmoquery
This document discuss a common issue observed during the VMM integration & VM workload migration to ACI fabric.
VMware Virtual machines are hosted in Cisco UCS-B seri...