cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1539
Views
0
Helpful
1
Replies

Distribute list in Nexus 7K to allow only default route

smondal10765614
Level 5
Level 5

Hi All,

We are about to migrate our core routers into two Nexus 7Ks with four VDCs each.

I was planning to permit only the default route (0.0.0.0) into the building aggregation switch (Cisco 6509). I planned to use distribute-list as I have done it in IOS and I could allow it through any specific interface I want.

Well, how do I do that in Nexus 7K? I don't see any distrubute list option. I can use prefix list, but then how do I specify the particular interface?

Many thanks in advance.

Mondal

CCIE #29034

1 Reply 1

smondal10765614
Level 5
Level 5

Well, I found my own answer!

Here is the command that goes on the Interface. I kept typing IP eigrp and hence did not get any option! Thanks for looking. You do offset-list the same way.

ip distribute-list eigrp Test1 route-map EigrpTest in

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: