Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Enable Jumbo Frames

Hello,

As I understand form a TAC case for enabling Jumbo frames on my N5K is :

switch(config)# policy-map type network-qos jumbo

switch(config-pmap-nq)# class type network-qos class-default

switch(config-pmap-c-nq)# mtu 9216

switch(config-pmap-c-nq)# exit

switch(config-pmap-nq)# exit

switch(config)# system qos

switch(config-sys-qos)# service-policy type network-qos jumbo

....What I need to know is how to remove this command if we run into issues.

Thanks in advance!


Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Enable Jumbo Frames

You should be able to re-attach the default policy

system qos

  service-policy type network-qos default-nq-policy

HTH,

jerry

1 REPLY
Cisco Employee

Enable Jumbo Frames

You should be able to re-attach the default policy

system qos

  service-policy type network-qos default-nq-policy

HTH,

jerry

745
Views
0
Helpful
1
Replies
CreatePlease to create content