Hi There !!!!!!! Anybody could confirm me if I can create a Po with LACP between a NX2000 and a ESX vConsole Server. The most strange thing is that the po between de Nx5000 and the ESX works, but in the NX2000 didn't. I add the log below:
5K-01 %ETHPORT-2-IF_DOWN_ERROR_DISABLED: Interface Ethernet100/1/14 is down (Error disabled. Reason:'set dscp/prec' is not supported on this platform)
The error "Error disabled. Reason:'set dscp/prec' is not supported on this platform" stated that you have some kind of QoS policy which it is setting DSCP or IPP to the inbound packet, and it is not supported on the N2K.
Thanks a lot for your quick response. I would like to know if I can create a Po in a NX2000 (N5k Parent) with LACP, a friend of mine told me that the servers ESX have a vswitch that don't understand LACP and the only mode to configure the Po is in mode on (Nx side). I believe in my friend but I need any Cisco Document that show me this explain.
In the Other side if I create the Po in mode on (without LACP) the channel brings up without problems.
I Think that is a Limitation of the ESX but I need to show my CU in an official Cisco Document.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...