I'm not familiar with the Nexus architecture, so i'd like to know whether there is any special consideration I have to make if I need to replace a FEX 2148 with a FEX 2248. For example, Do physical connections remain the same (basically just plug and play)? Do I have to make any change in the configuration or it is basically copy / paste?. Is there any change I have to make in the nexus NX5K the FEX is connected to?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...