Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Hi All

Need a help in the below attached jpg for the switching .

Regards

Sudharsan.R

91+8220088865

1 REPLY
Cisco Employee

Hi All

Hi Sudharsan

First you need to check config on 2960 switch whether access vlans are set correclty.

Then check config on n5k.

links on sw 13 - g1/21 and g1/23 can be configured as one portchannel, 22 and 24 as the second and 2 vpc portchanels from n5k side.

Then reenable shutted links between sw 13 and nexuses. If loop will occur - stp will block it, if not - check which link causes loop.

HTH,

Alex

697
Views
0
Helpful
1
Replies
CreatePlease to create content