Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip pim neighbor-policy not working on Nexus 7K

Hi all,

 

I have the following configuration on a couple of Nexus 7K:

N7K-1

interface Vlan3
  vrf member TEST
  ip address 10.139.7.252/22
  ip pim sparse-mode
  ip pim dr-priority 100
  ip pim hello-interval 5000
  no shutdown

 

N7K-2

interface Vlan3
  vrf member TEST
  ip address 10.139.7.253/22
  ip pim sparse-mode
  ip pim hello-interval 5000
  ip pim neighbor-policy FILTER-PIM-MAP
  no shutdown

ip access-list FILTER-PIM
  5 deny pim 10.139.7.252/32 any 
  6 deny pim 10.139.7.252/32 224.0.0.13/32 
  10 deny pim 10.139.7.252/32 any 
  20 permit ip any any 

route-map FILTER-PIM-MAP permit 10
  match ip address FILTER-PIM

 

 

Neighbor-policy is not working. PIM neighborship on SVI 3 is still up between Nexus 1 and 2.

Does anybody know what is wrong on the route-map and ACL?

 

Regards

Stefano

 

Everyone's tags (1)
1 REPLY
Cisco Employee

you need to use prefix-list.

try this

ip prefix-list mynewnb seq 15 permit 10.1.1.0/24 eq 32

route-map PIMNBRM permit 10
match ip address prefix-list mynewnb

interface Ethernet3/1
delay 100
bandwidth 1000
no ip redirects
ip address 20.1.0.1/16
ip pim sparse-mode
ip pim neighbor-policy PIMNBRM
no shutdown

47
Views
0
Helpful
1
Replies