Is it possible to configure non-default NX7K CoS-DSCP map?
NX7K QoS has system defined table maps for CoS to DSCP mapping, DSCP to CoS mapping, etc. Those table maps can be used in qos policy maps. I was wondering if I can change, for example, CoS to DSCP mapping to something different from the default values.
Somthing similar to Catalyst switch command "mls qos map cos-dscp 0 10 18 24 34 46 48 56", where you can define any CoS to DSCP values. I don't think this is possible in NX7K QoS, but just curious.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...