Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Minimum NX-OS to support NX7K M1 and F2e module ports in the same VDC?

I have M1 48-port RJ-45 module and F2e 48-port SFP module in a 7K chassis. I like to have the ports from the two modules in the same OTV VDC (M1 ports for join interface and F2e ports for internal interface). Is NX-OS 6.2 the minimum to support M1 and F2e in the same VDC?  

Thanks               

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Minimum NX-OS to support NX7K M1 and F2e module ports in the sam

Hi,

Yes, you need 6.2(2) release to support F2e and M1 in same VDC

http://www.cisco.com/en/US/docs/switches/datacenter/sw/nx-os/virtual_device_context/configuration/guide/vdc_mgmt.html

Regards,

Sandip

1 REPLY
Cisco Employee

Minimum NX-OS to support NX7K M1 and F2e module ports in the sam

Hi,

Yes, you need 6.2(2) release to support F2e and M1 in same VDC

http://www.cisco.com/en/US/docs/switches/datacenter/sw/nx-os/virtual_device_context/configuration/guide/vdc_mgmt.html

Regards,

Sandip

1072
Views
0
Helpful
1
Replies
CreatePlease to create content