I've N2K connected to N5K in single home. We purchased GLC-T for Nexus 2k to connect the 1G servers. I observed the following error and then, the PS is showing 'absent' in the environmental output... I'm wondering whether the change in speed to 1G forced this behaviour or it is due to some other issue. Can you please suggest to proceed... Thanks
NX-OS Version 5.1(3)N1(1a)
2012 Mar 21 11:48:42 Switch last message repeated 41 times
2012 Mar 21 11:48:42 Switch %SATCTRL-FEX122-2-SOHMS_DIAG_ERROR: FEX-142 Module 1: Runtime diag detected major event: GPIO access failure
2012 Mar 21 11:48:46 Switch %SATCTRL-FEX122-4-SOHMS_PS_GPIO: FEX-121 System PS access failure on Power supply: 1
2012 Mar 21 11:48:47 Switch %SATCTRL-FEX122-4-SOHMS_PS_GPIO: FEX-121 System PS access failure on Power supply: 2
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...