Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

N7K-F248XP-25E not accepted

Hi all,

I´ve got a problem with a new line-card I´d like to install in our Nexus 7010.

Informations around the N7k:

Installed SW (system/kickstart) NXOS 6.1(1).

3x 6kw power.

Line-Card should be installed in Slot 8. There´s already a F-card (N7K-F248XP-25 -> without E in the end) installed in slot 1. This one is absolutely fine. The new line-card is only recognized when I do a "show environment power". Then I can see the model and status is "Powered-Dn".

When I do a "show module" it says "Unknown module" and Status is "powered-down".

I did a "no poweroff moduel 8"...logg says "Unknown card. Could not get software-id-card.

Do you have any ideas, what is wrong or what I can do to get the card up and running?

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions

N7K-F248XP-25E not accepted

Check this link

http://www.cisco.com/en/US/docs/switches/datacenter/sw/6_x/nx-os/release/notes/61_nx-os_release_note.html

You need to upgrade your code to 6.1(2).

Don't forget to rate all helpful posts.

2 REPLIES

N7K-F248XP-25E not accepted

Check this link

http://www.cisco.com/en/US/docs/switches/datacenter/sw/6_x/nx-os/release/notes/61_nx-os_release_note.html

You need to upgrade your code to 6.1(2).

Don't forget to rate all helpful posts.

New Member

N7K-F248XP-25E not accepted

Thanks for that information...will update the SW.

1261
Views
0
Helpful
2
Replies