Funny this one. I opened a case with our vendor. They came onsite, and did the same commands that I had done earlier.
I had also tried power it off/on in different ways. When my vendor did the same, it startet with normal boot sequence and load software and config. Now it runs ok. I have even rebooted it a couple of times after this, and now it seems to be working fine. Expensive troubleshooting from my vendor there :-(
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...