Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

lap
New Member

NEXUS 5K always entering in boot mode when booting

Hi,

Some of our customer has trouble with one of his Nuexus 5k which always enters in booting mode after power outage for example. I attach a file of the log showing the messages that were displayed on the console when this error occurs.

Regards,

Laurent

Everyone's tags (6)
2 REPLIES
Cisco Employee

NEXUS 5K always entering in boot mode when booting

Laurent,

I see the following.

## Failed: PCI device - Intel 82575EB Gigabit Ethernet Controller

           (bus:02, dev:00, func:00, vendId:8086, devId:10A7)

## Failed: PCI device - Intel 82575EB Gigabit Ethernet Controller

           (bus:02, dev:00, func:01, vendId:8086, devId:10A7)

## Info : Based on P0 board detection.

Power-On Self Test fatal error: PCIe error

Power-On Self Test fatal error: PCIe error

Power-On Self Test fatal error: PCIe error

This appears to be a possible hardware problem, I would recommend opening a RMA for replacement.

lap
New Member

NEXUS 5K always entering in boot mode when booting

Hi Colby,

Thanks a lot for your reply.

We will so proceed and open a RMA for replacement.

Best regards,

Laurent

1319
Views
5
Helpful
2
Replies