I'm set up e new 2 Nx 7k in a customer DC, and 3 questions arises during off-line configuration:
1 - since we have only 1 F1 module, where we are going to setup the peer-link how many track have I to define? one for each vPC link (ie: if I create 4 vPC have I to track all of them?)
2 - we just discovered that on Nx 7k "dhcp server" is not supported ... any ideas on how to bypass this problem? The actual switch (a 6513 with CatOS and IOS ....) acts as dhcp server for 2 network, following the configuration:
ip dhcp excluded-address 172.27.110.1 172.27.110.143
ip dhcp excluded-address 172.27.101.1 172.27.101.132
ip dhcp ping packets 3
ip dhcp pool IpPhone
network 172.27.110.0 255.255.255.0
option 150 ip 172.27.112.19
dns-server 172.27.120.7 172.27.120.8
ip dhcp pool AccessPoint
network 172.27.101.0 255.255.255.0
option 43 hex f104.ac1b.6cc9
option 60 ascii "Cisco AP c1130"
3 - I found others command which are not supported by NX-OS, any clue?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...