I know that N7K did not have N+1 Switch Fabric redundancy. It is required to have all five SF modules to provide full throughput. Does this change with FAB-2 modules ? I mean with new modules, does N7K have N+1 SF redundancy ?
The N+1 fabric redundancy will depend on the type of module.
If you are using M132 (80G) per slot and you have 3x FAB-1 (46G each), it will provide N+1.
The same story applies to FAB-2. If you are using the F1 series, and have 4x FAB-2, you have N+1. Of course, if you are using F2 series linecard and have all FAB-2 populated, you don't have N+1 because F2 is 480G and all 5 FAB-2 will give you 550G.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...