07-14-2017 02:36 AM - edited 03-01-2019 08:35 AM
Hi,
We are migrating customer 6513 switch with Nexus 7706 switch but some of the commands are not supporting. I have tried converting the commands using IOS to NX-OS toool but still getting the issues.
I am new to IPV6 addressing but simply trying to copy from 6513 switch to Nexus 7706 switch but getting the below error.
Examlpe 1:
Configuration from 6500 switch:
interface Tunnel111
no ip address
ip broadcast-address 0.0.0.0
ipv6 address ABCD:172:24:255::/64 eui-64
ipv6 enable
ipv6 rip IPV6 enable
tunnel source Loopback178
tunnel destination 10.223.255.123
Nexus switch is not supporting the above bold command and showing the below error
N7K-CORE(config-if)#interface Tunnel111
N7K-CORE(config-if)# ipv6 address ABCD:172:24:255::/64 eui64
IPv6 tunnels not supported -- error
Can any one advice please.
Note: I have enabled "feature tunnel"
Thanks,
Ashok
07-14-2017 02:39 AM
Hi,
Apart from the above the below command under svi is also not supporting.
ipv6 dhcp relay destination 2620:0:1AA0:8070:1:1:2:1
Thanks,
Ashok
03-15-2018 09:06 PM
This document describes the features, caveats, and limitations for Cisco NX-OS software for use on the Cisco Nexus 7000 Series Switches. Use this document in combination with documents listed in the “Related Documentation” section.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/nx-os/release/notes/62_nx-os_release_note.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide