Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

Nexus 7710 Port-Channel with f2e and f3


We have two Cisco Nexus 7710 with the following HW configuration

Slot 1: N77-F348XP-23

Slot 2: N77--F248XP-23E

Slot 5: N77-SUP2E


When I try to create a LACP portchannel with one port on F3 and another port on F2e I receive this error (when i try to bundle the second port to the channel):

"command failed: port not compatible [Module Type Incompatible]"

I suppose that there is no compatibility between the two modules (F2e and F3). Can you tell me if there is a Cisco Document that explain this? I cannot find it.


Thanks in advance

Cisco Employee

What is the NX-OS version you

What is the NX-OS version you are running. You need atleast 6.2.6 to support the inter-operability. Check the release notes below.



New Member

It says..."With Cisco NX-OS

It says...

"With Cisco NX-OS Release 6.2(6), you cannot interoperate the F3 Series plus the F2 and/or F2e Series plus the M2 Series modules in the same VDC."


If I've understood not possible to do a LACP etherchannel on two different modules...right?

CreatePlease to create content