07-04-2013 01:03 PM - edited 03-01-2019 07:21 AM
I have a question. I have a pair of nexus 7k's running in production. They are configured on the default VDC and using the mgmt0 interface as the vPC keepalive link. I created a new VDC labeled TEST and wanted to setup vPC and fabricpath on my new VDC. But should I use the test VDC mgmt0 for my keepalives or will that break my production setup? Can I set it up over an SVI ? Any advice would be appreciated!
Thanks
Timmyz
Sent from Cisco Technical Support iPhone App
Solved! Go to Solution.
07-04-2013 11:47 PM
You can re-use the mgmt0 interface for vPC keep alive in the new VDC.
This interface can have a unique IP address in each VDC.
See below:
Don't forget to rate all helpful posts
07-04-2013 11:47 PM
You can re-use the mgmt0 interface for vPC keep alive in the new VDC.
This interface can have a unique IP address in each VDC.
See below:
Don't forget to rate all helpful posts
07-05-2013 09:03 AM
Thats it!! thank you very much. I am up and working.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: