Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NX7K M and F series mixed chassis best practice?

I have NX7010 chassis' with mixed M and F series line cards. Fucntions to implement include VDC, vPC, VRF, and L3 routing. What are the best practices for mixed chassis? I once saw a Cisco document talking about it but couldn't find it right now.

Thanks in advance                 

2 ACCEPTED SOLUTIONS

Accepted Solutions

NX7K M and F series mixed chassis best practice?

Did you mean F1 and M1 cards? If so see below

http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/VMDC/2.6/vmdcm1f1wp.html

Don't forget to rate helpful posts.

NX7K M and F series mixed chassis best practice?

I've found this to be a helpful quick comparison for the line cards:

http://www.cisco.com/en/US/products/ps9402/prod_models_comparison.html#~tab-c,

4 REPLIES

NX7K M and F series mixed chassis best practice?

Did you mean F1 and M1 cards? If so see below

http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/VMDC/2.6/vmdcm1f1wp.html

Don't forget to rate helpful posts.

NX7K M and F series mixed chassis best practice?

I've found this to be a helpful quick comparison for the line cards:

http://www.cisco.com/en/US/products/ps9402/prod_models_comparison.html#~tab-c,

New Member

NX7K M and F series mixed chassis best practice?

Thanks both.

New Member

NX7K M and F series mixed chassis best practice?

Understand Layer 3 functions should be performed by M1 ports. But if I use F2e 10G ports to build a trunk between 2 NX7K, then use a SVI to make Layer 3 adjacency across this trunk connection, is it ok?

I can use M1 1G ports to build this trunk too but I would prefer F2e 10G ports if this is ok.

Thanks

1499
Views
0
Helpful
4
Replies
CreatePlease login to create content