I have a SM-32A module installed in slot 1 in a Cisco 3925 router to act as a terminal server providing reverse telnet sessions to various other device console ports. My understanding is that the ports on the SM-32A are referenced as "slot/port" - in my case 1/0-31. The terminal server L0 address is 220.127.116.11 What I cannot determine is do I need to configure an ip host table with conventional port numbers to facilitate connections e.g.
ip host R 2000 18.104.22.168
ip host R1 2001 22.214.171.124
ip host R3 2003 126.96.36.199
ip host R31 2031 188.8.131.52
If so, are the port numbers 2000 to 2031 or is another convention used?
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...