Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VACL on N7k with F1 cards

Hi

I have a nexus 7010 with one M1 card and two F1 cards. I´m trying to set up packet capture for an IDS using VACL.

It seems that ACL capture is not possible with F1 cards. Is this correct?

Regards

Björn

3 REPLIES
Cisco Employee

VACL on N7k with F1 cards

Hi Bjorn,

You are right, ACL capture is not supported on F1 series LC, it is supported on M1 series LC

Look at "F1 Series Module" on below document

http://www.cisco.com/en/US/docs/switches/datacenter/sw/6_x/nx-os/security/configuration/guide/b_Cisco_Nexus_7000_NX-OS_Security_Configuration_Guide__Release_6.x_chapter_01110.html

Regards,

Sandip

New Member

VACL on N7k with F1 cards

Thanks for the Link.

Does this mean I am limited to 2 standard monitor sessions (running NX OS 6.0) for capturing traffic? Or is there some other method I have missed?

Cisco Employee

VACL on N7k with F1 cards

Hi Bjorn,

Cisco NX-OS Release 6.2(2) and later releases support extended SPAN sessions in addition to the two traditional SPAN sessions. You can configure 16 sessions as unidirectional or bidirectional, as required.

Look at Extended SPAN Session on below document

http://www.cisco.com/en/US/docs/switches/datacenter/sw/6_x/nx-os/system_management/configuration/guide/sm_14span.html

Regards,

Sandip

971
Views
0
Helpful
3
Replies