Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPC consistency check error

I have 2 Nexus 5548 switches. I'm facing issues on VPC status down and consistency check not performed.

Below is the output.

vPC status
----------------------------------------------------------------------------
id     Port        Status Consistency Reason                     Active vlans
------ ----------- ------ ----------- -------------------------- -----------
216    Po216       down*  Not         Consistency Check Not      -
                          Applicable  Performed

 


C5548SH02(config-if)# sh vpc brief
Legend:
                (*) - local vPC is down, forwarding via vPC peer-link

vPC domain id                   : 100
Peer status                     : peer adjacency formed ok
vPC keep-alive status           : peer is alive
Configuration consistency status: success
Per-vlan consistency status     : success
Type-2 consistency status       : success
vPC role                        : secondary
Number of vPCs configured       : 93
Peer Gateway                    : Enabled
Peer gateway excluded VLANs     : -
Dual-active excluded VLANs      : -
Graceful Consistency Check      : Enabled

 

3 REPLIES
New Member

Hi SushilIt seems your vpc

Hi Sushil

It seems your vpc peering is perfect but there is some problem with the port channel configuration (po216). It would be nice to share the configuration. The port configuration must be same on both switches part for physcial interface. 


sh run interfac po216 

sh run inter ethernet "physical port number "

 

see port configuration on following example

 

sw01# sh running-config inter po 12

!Command: show running-config interface port-channel12
!Time: Mon Oct  6 12:19:53 2014

version 5.2(1)N1(7)

interface port-channel12
  description data
  switchport access vlan 2106
  spanning-tree port type edge
  vpc 12

 

sw02# sh run inter po 12

!Command: show running-config interface port-channel12
!Time: Mon Oct  6 12:20:46 2014

version 5.2(1)N1(7)

interface port-channel12
  description data
  switchport access vlan 2106
  spanning-tree port type edge
  vpc 12

New Member

Hi Syed,see below port

Hi Syed,

see below port-channel config and interface config. both are identical.

 

N5k-SW1
interface port-channel216
  switchport mode trunk
  spanning-tree port type edge trunk
  vpc 216

interface Ethernet106/1/16
  description SWIGEDPM200
  switchport mode trunk
  spanning-tree port type edge trunk
  channel-group 216 mode active

N5K-SW2
interface port-channel216
  switchport mode trunk
  spanning-tree port type edge trunk
  vpc 216

interface Ethernet107/1/16
  description SWIGEDPM200
  switchport mode trunk
  spanning-tree port type edge trunk
  channel-group 216 mode active

New Member

May be the output of

May be the output of following would help 

 

sh vpc consistency-parameters vpc 216 

sh vpc consistency-parameters global

and also the ouput of sh inter po xx from the far end switch ? and if its server than please double check the lacp config are correct etc.

207
Views
0
Helpful
3
Replies
CreatePlease to create content