Other Network Architecture Subjects

I have two switches connected together via a isl trunk. 5505 is set to vtp domain phx and the 4506 is set to phxeng. They are both on and transparent mode. One has version 2 enabled the other has version 2 disabled. The 4506 is running ios the 5...

We have one Central site and many remote site.Central site is ATM-A3-OC3SMI and remote site is ATM-e1.Our diagram is Central Router l (Atm-60M) l ISP ATM l.......

We have an outside vendor touting an appliance that will increase throughput on WAN links substantially. They are stating they can get a link to run 100% but without their product, the links won't run nearly that. Can anyone give me any information ...

I am routing ipx through a 6509 MSFC and have a question on how the router responds to GNS requests. I'm routing 802.3 ipx packets ( Novell-Ether) but some of my servers are also configured to run 802.2(SAP). The MSFC is not configured to route 802...

Hi. I am gathering network traffic stats using RouterSrcPrefix aggregation scheme definition of netflow. Our billing system needs this aggregation scheme. I see in output file of netflow collector v4:- -SOURCE 70.79.141.232|FORMAT 2|AGGREGATION Route...

Greetings!I am new to Switch monitoring. I have setup span in a 2900 cisco switch. The actual command i used is: "set span 2/1 3/25". But it is not giving the full traffic. Am i missing out anything?Thanks and Regards,Saifullah

Quick question...Reviewing a network configuration in which a Cat5500 w/rsm is in the core of the main site (roughly 150 remote sites, most over FR links). It's working fine, some issues but outside the scope, and configured properly IMO. My questi...

pls post me how ?I tried 2950T ------ 2950G and 2950G ---- 3550via trunk 802.1q trust cos , and input port uses cos 5use smartbit to pump traffic

Command "default-information originate" in isis enable L1L2 IS generates a 0.0.0.0/0 prefix in its Level-2 lsp.But what will happen if the L1L2 IS is unattached from backbone?dut1-----L2(LAN1)--------dut2 | | |______L1(LAN2)__...

Hi,I've got a new install of ITM 2.0 withITM 2 IDU 1.0GW Stats UtilIP Phone Helpdesk UtilIP Phone Info UtilI have all the media servers and phone-supporting switches without any problems.In the IP Info Util if I try to add a discovery schedule for ph...

I have a cisco 3640 Router and behind that i have four terminal servers. I want the Cisco Router is do a tcp load balancing on roud-robin fashion between these four terminal servers when connecting from systems that are in the other side of the route...

for some reason load balancing is not working the router is only using the 1Mbps link .....

I have a Cisco AS5300 Access Server that is currently connecting to two ISDN/23 (under a prime number and within the same hunting group). Remote users can dial into Corporate network without problem. Now, I plan to let users to dial out via this AS53...