Other Network Architecture Subjects

I have added about 70 devices into RME, but 12 just don't want to play. These 12 all end up not responding with an error of: "The SNMP request has failed due to: TimeoutTimeout" Funny thing, when I use the same SNMP strings in CiscoView, the device...

I attend a Cisco Academy. In my lab I am required to make six router be able to communicate via Serial ports. Even though my configuration appears to be working, I cannot ping other routers from the CLI. Is there a command or protocol that I am missi...

This is my net design, my AS is AS22222.AS11111 <--EBGP--> AS22222(routerA)<--IBGP--> AS22222(routerB) <--EGBP--> AS33333routerA receives 126458 nets from AS11111, routerB receives 127557 nets from AS33333.I have something strange on my routerA. In t...

How do I exclude an IP address from sending out ICMPs in CiscoWorks?

Does anyone know if a command exisits to show the mac-address of the devices connected to a Cat2980G ?If not can anyone tell me a way of tracing/locating a device using only its mac-addressThanks

How do I filter out IA routes. I want all my areas to only have routes from their own area and the default(s) to area 0. Is there an ospf mechanism to do this or do I have to use access-list and dis-lists?tia

Does anybody know what's the purpose of LSA type 4, ASBR summary LSA. My understanding is LSA 5 (AS external LSA) will flood to all the routers which are in OSPF autonomous. So why we need LSA 4, unless LSA 4 is used to update the gateway to all intr...

I have a router interrupt utilization quite high. How to determine what the cause of this high interrupt utilization. The cef and the netflow switching has been enabled already.show proc cpuCPU utilization for five seconds: 78%/76%; one minute: 60%; ...

I would like to console into any of my 30 cisco devices from anywhere on my network. Anyone have a suggested device to terminate all the console connections? It would be a device that can be placed on the network with an IP and then connect to that...

If I have multiple atm subints and each of the subints have their own pvc which is a part of one or another bridge-group, can I assign an access-list to the BVI interface instead of each individual sub-interface?Thanks

Does anyone has a model to interconnect two SW6509 chassis each one with dual MSFC2 and SUP2, and two SW4000? I am thinking in a sqare type with the two 6509 interconnected via SUP2 and each one with one etherchannel to each SW4000.Is there any confi...

Hi,I have a satellite network which needs to be fully meshed. What is the best protocol to use for this, OSPF? I need this so I can decrease the delays between the remote sites to a single hop. Instead of a double hop via the HUB site. The network wi...

I've two 7200s:-the first was bought as a stand-alone 7200-the second was bought with an AS5800 to be a dial shelf controller These two 7200s are identical for memory and CPU, they are without any PAs.I've configured these two routers to get the IOS ...

Hi all,i have VMS installed in my server, he manage 5 ids 4235 and 2 PIX 515 en failover , i use IDS MC and SECURITY MONITOR. i see in my log 2 file , syslog and idsmdc in this path c:\program file\csopx\log and c:\program file\csopx\mdc\sybase\ids.t...

Hi,Anybody know about ADSL modes or ADSL line characteristic and difference between them?it seems we have Fast and interleave major modes.which is better in which situation?i would be grateful if you advice me.Kind Regards,M.Arshad Rad