I have an existing network ( 20.0.0.0) with eigrp working on AS 10 at the main site (rtrA). At the remote site, also eigrp AS 10 with network 20.0.0.0 (rtrB). This two are connected together. I have a new link from the same router (rtrA) going to a n...
I'd like to test simple GRE tunnel between two routers. Routing between the two routers are fine. However I can't ping the tunnel interface. Debug tunnel only shows outbound packets:Tunnel0: GRE/IP encapsulated 2.2.2.2->172.32.10.1 (linktyp e=7, len=...
We have a Router 7204VXR, the fastethernet 0/1 lost the communication and blocking port, but the port continue up, the solution is reset port (shutdown, no shutdown), Somebody knows this problem?
Hi,First let me tell you that I new at configuring routers.I have a Cisco 2611 which I would like to configure to use ADSL and in case of connection failure switch to ISDN.When the connection is restored, it should switch back to ADSL.Please look at ...
Hi, We have a IPLC Leased line circuit between our two offices and data,voice(IP Phone) and video traffic pass through this link. I have configured CBWFQ with LLQ and set priority for voice and video and fair-queue for data. The Video conference equi...
HiI am connecting a 3550 Cisco switch to an extreme layer 3 switch is a different product.The extreme switch is the core switch running all the Vlans for this office.I am connecting another layer 3 switch to it because I have a laser connecting to it...
Hi,We have the following environment:Cat5000 <--isl trunk--> Cat2924 <--dot1q trunk--> Cat2950We had to use ISL trunking on the first leg because even though the CatOS on the Cat5000 supports dot1q, the particular module (WS-X5111) only supports ISL....
Hi,I have two NAM installed on 2 Cat6K Core Switch. With nGenius, I saw that the Application Layer Data for the two NAM for the Same VLAN over the same period is different, for example, VLANx on NAM1 will display Application Layer Data, at the same t...
The 3662 crash after the CW2000 connect to network and enable CDP at the fastethernet port~The system return error messages below:00:34:12: %SYS-2-WATCHDOG: Process aborted on watchdog timeout, process = IP SNMP.-Traceback= 602DCE8C 602E0948 602D8C7C...
We have a 5505 running SW 5.2(4) and a 2924 running SW 12.0(5.4)WC(1. We need to run a VLAN trunk between them. Does anyone know if this is possible and what are the "gotchas"?Thanks.
Hi,I´m having a bit of trouble when I connect a 7206VXR IOS 12.2(12b) via a Fastethernet port to a Riverstone 8600. When I do an extended ping >1000 I see a 2% packet loss. It looks like there's a pattern but we don't know why. I've done the same tes...
