Other Network Architecture Subjects

Hi,We want to limit the usage of hhtp type traffic in our branches( in any case).I know CAr rate limiting and also policy based rate limiting can be a solution.But When I implemented car rate limiting feature to router I didn't see any impact of it.C...

Came across this formula in CCNP studies for determining number of adjacencies required when using BR and BDR in a full mesh environment. The formula is 2 x (n-1) where n = number of nodes. Taking a 4 node situation, the number of adjacencies woul...

Hi,I have the following situation:-------- ---------R1 |--------GRE TUNNEL---------| R2 |------FastEternet0/1 to Internet-------- ---------R1 uses IP address 10.1.5...

Hi, When i monitor the "Show standby " command output--- Local state is Init (interface down) I have shutdown the interface manually to check the hsrp fucntion,could be administratively down.Any idea would be appreciated. Thanks

Hello.Can I configure bridging on the 4506-SupIV ?I need to configure some interfaces with ip-address and bridging between them ,Can I do it ?How?Boaz.

I am trying to use a 3640 router as a gateway router for a new fibre line I have installed. This router was previously used as a gateway router for a T1 line. Can this be done. The fibre line terminated as an RJ45 connection. Appreciate someone helpi...

Hi, When i monitor the "Show standby " command output---Local state is Init (interface down)I have shutdown the interface manually to check the hsrp fucntion,could be administratively down.Any idea would be appreciated.Thanks

Hi,I have a CSS 11000 and here's the problem.Switch IP is 172.16.40.2Two servers behind the switch with following informationServer1 IP 172.16.40.4Server2 IP 172.16.40.8I set up a rule called SURV01.i set up a virtual ip of 172.16.40.50I set up two s...

Hello guys,we are trying to check the performance on our 34Mbit telco connection. my questions is: wich command i should use to check this on a cisco 3640 , 2620 and cat 2548xl ?Thanks for any helpA.E

Hi, I have a server connected to a Gigabit Ethernet Port on a catalyst 5509 with flowcontrol enable. We lost connectivity to the server and the number of RxPause in the "sh port" output of the Catalyst GE port increased a lot. We already solved the ...

I have an application, and I am wondering if I can or need to route VLANS.****I have a Main Site and a Remote Site. I have CISCO 2620 Routers at both ends of a Point to Point T1 link. Both routers's Fa0 ports are plugged into CISCO 2950 switches.**...

VPN concentrator has excellent support in Ciscoview, but nothing else in Ciscoworks. When will this change? Patches needed? Suggestions?PIX works with Config editor, but still nothing in Netconfig. Patches needed? When supported?

The downloadable patches on Cisco.com only have database upgrades from CD-1 3rd edition to 5th edition.How do I upgrade from 4 to 5 edition for CD-1? Where do I get the downloadable file? Extra cost?