Other Network Architecture Subjects

From CiscoView, i try to enable a port in a Catalyst 6500 but i get SNMP timeout error. But CW2K server is directly connected to the switch, but devices beyond this switch are configured with no problems.Somebody have an idea?Thanks

Hi AllI like to use this command to capture traffic from an acl and then forward it to a syslog server .... but for some reason on my routers, it doesnt work anymore. Logging is on at level debugging, has any one had any problems with this feature be...

I am trying to use the VOIP Monitor server on the CRS platform. I am running into trouble because the Monitor server monitors the IP Phones by MAC address. I can monitor calls if the Monitor server and IP phones are in the same VLAN. We have 350 P...

HelloI would like to use the router as DNS for clients on a remote site. The router will resolve names in a "Real" DNS, and cache the replies before forwarding them to the clients. That way the clients will be able to resolve the most used names even...

how to config Pa-mc-stm-1smi on 7507 router ?who have the example of the configure in China? I don't known the configure is diff between China and the other nationpls tell and help methanks

Is it possible to map an outside address to a server that is inside a network and connected through another router? Here is the layoutMain router 10.2.1.xcisco switch 10.2.1.xnext router connected to switch 10.16.1.xCan I map a static outside ip to ...

Do 3600 series routers support WIC for Cable Modem? I know 3600 does support WIC for DSL technologies, but don't know if it will support Cable Modem.Thanks

In the 3550 you setup the switch's internal management vlan via "Interface vlan x" and specify an ip address. However, you issue the exact same commands for a routed SVI/Vlan. How do you tell the switch which vlan is his internal management vlan, and...

Hi All,Understand from this http://www.cisco.com/pcgi-bin/ecoa/displayProfile?PARTNER_ID=286#fnbwe can integrate ciscoworks with Netview 6.01. I am running LMS 2.1 on Windows 2K with SP2 and AIX Netview 7.1.2 and my next project is to integrate the...

Anyone know if an RSP1 is still supported by Cisco or if they declared it end of life? Any documentation I have found only references RSP2.

Hello,where can I find a detailed document about facilities and severities?I need to log only particular event of sys, telnet and so on.Thanks.Andrea.

This morning one of our 2950 drop offline. When I access it through the console the following error kept showing up SCHAN ERROR INTR: unit=1 SRC=6 DST=5 OPCODE=20 ERRCODE=5. I reloaded the switch and it is working well but I was just curious if...