Other Network Architecture Subjects

is there any issue or difference in the configuration of the 8 port analog modem on the 2600 series and the 2651 router? because i copied the configuration of the nodem from a 2620 and transfer it to the 2651 and it did not work? anyone can tell if t...

I have installed one port channelized E1/ISDN PRI to my Cisco 2600 router.After install I observed that the local alarm LED (orange light ) is on.What that means ? Do the interface have an hardware problem ?

I have a network module of E1/ISDN PRI.When I boot my router , i found that the LED signal for the CARRIER DETECT is on immediately.But there is no ISDN PRI connection connected to the interface.Is this is a hardware error ?

To configure a ISDN PRI (E1) 30 channel for leased line backup , should I create serial0/0:15 or serial0/0:23 or serial0/0:30 ?Do I have to create the Dialer profile for the serial interface which I create for the ISDN PRI ?

How do I set the Cisco 804 isdn router to dial out on the 2nd channel first, then use 1st when needed? And which interface would need to be configured?

I've read on the site that begining with IOS version 12.1.3 there's a capability to emulate ISDN cloud in the router with NT1 interface. I guess the dial-up client routers would be equipped with ISDN S/T BRI interfaces. I wonder if anyone was able to...

I have a AS5350 with PRI network module with NP108 digital modems. The PRI line has not been provisioned, and I am trying to test the mode result code (ie. "NO CARRIER") via reverse telneting and manually issuing ATDT command. I don't see any codes....

What's the standard way to set up time for your network devices when you have offices in the US, Canada, the UK,...? Is it better to set up the local time of our HQ everywhere?

What's the standard way to set up time for your network devices when you have offices in the US, Canada, the UK,...? Is it better to set up the local time of our HQ everywhere?

I want to know if Mica Modem support MNP10 protocol (error controlenhancements for cellular)

I need to configure my isdn bri interace to dial and come up when the primary serial interace reaches 90% of the link speed.

I am connected to a as5300 through the console port and when I hit return to enter the system it tells me to hit return to continue. I hit return and it tells me again to hit return. I captured the following:%SYS-4-CONFIG_NEWER: Configuration from ve...

when I boot my AS5300 I always see this message.. does it have implications if it will support all hardware?Firmware version mismatch for bundle AS5300 VCWare - version found (7.23) is lower than minimum required (7.39)Firmware version mismatch for ...

I am looking at a new laptop and I notice that many no longer have serial ports but 2 usb's. I also have an Imac with usb ports how can I configure a router with this?

"TFTP Write c:\config at 10.0.39.24 on interface 1 Unspecified Error[FAILED]