Other Network Architecture Subjects

I have configured 3 NAMs in 6509s, using the NAM6KPROP11 properties file. When I view stats for Traffic Monitor and Segment Zoom, I don't get any vital signs, % Utilisation and Unicast/Broadcast/Multicast% statistics, but I do get packet size and de...

I am requiring to implement QoS in a Private Vlan environment.I want to limit customer traffic going through a particular MAC address without using MSFC( only with the PFC card ).I need this traffic be limited only by the switching process( PFC 2 )...

Hi everyone,I've implemented policy based routing to figth against NIMDA; to apply theese policies on Cisco 7500with VIP2-50 I nedeed to use Cisco IOS 12.1(7)E;the policies provide the matching of the strings of the URL on port 80, the setting of dsc...

Looking to use the 7200 series for a pt to pt DS3(electrical). Not sure about the ATM interface to the SAN solution and the implications this may cause for the SAN. Using Compaq Storage works and DRM.

I am working on a project that requires high-availability and failover protection. I just finished reading the white paper on high availability and have some design questions.1. In a mission critical scenario, where high-availability is required, i...

We would like to know, how to prioritize HTTP-Traffic over ATM-WAN-Links, which should be put in the LOW-Queue. All other traffic should have normal priority.We use IOS 12.0(7) on Cisco 2620.Best RegardsJoerg

We are using Polycom video systems on our company andI was assign to do it over the private IP backbone which consist of fractional T's to Europe. The first router hop bw is 1024 M and the second one is 1920K.I am presently using Low latency queueing...

I got a advise from a CCNP and it said that the encryption and compression are generally switched at processor level. For others such as ACLs, CBWFQ and Accounting, will the first packet is always consider in process switched ? Then, is it true if th...

i have a cisco 2620 and i want to connect it to my lan and work with netmeeting on my compiouters. in the incoming call no problem, but in the out going call i have a problem.i didn't know wher's the problem

I need to quote 2 x Catalyst 3550-12T switches for my customer with the ACLs feature. Does the Catalyst 3550-12T support the ACLs for all port ? If yes, does the ACLs still works when one of the (10 x 10/100/1000Base T ports)port was detected only 10...

Are there any Cisco (or other) design recommendations for implementing a scalable EIGRP network. For example (but not limited to):1.The maximum number of EIGRP neighbours.2.The memory/processor requirements (given the number of neighbours and size of...

We want compression on our WAN Link.On one end we have 3640 Router.The other end router is to be bought.I have searched and found that NM-COMPR Card is to be installed on this series for hardware compression.Now on the other end,if I use 2600 Series ...

How can I connect a Cisco 2600 router to my PC? I have a console cableRJ45 plug). I cannot get it to work with a network card port.Bob Peete

I have a problem that some users use many bandwidth and I would like to block them. How can I do on the router 7200? I have to use access-list or policy map? Can someone show config. command?

We have the configuration below:HSRP_Router_Pair<->Switch<->Stonebeat_ClusterThe stonebeat cluster uses a multicast MAC for it's virtual interface. When one of the routers sends a packet to the stonebeat cluster (ie. to the multicast MAC), the other ...