Other Network Architecture Subjects

Dear all,I have some problem and would like your advice as below.I performed some labeling and remove all three modules and re-inserted again, after that all three modules Status LED do not light and no response when I plug the cable to console port ...

Hi,I have a cisco 3660 with a chunk manager process at 9MB of memory load.I don't know because it's getting so high.There isn't any error message.Does anyone knows how I can resolve this problem?Thank you.Regards.

the problem started couple days ago, some of the switches down, i am thinking its pointing towards a loop in the network.Please advise what could be the actual cause and the best way to troubleshoot this..Thankss

We have a cat 6500 running in hybrid mode. With two MFSC2 in high-availability mode. We currectly run on the MFSC2 IOS ver 12.1(22)E. We are going to upgrade to 12.1(23)E4. I was wondering can I do that without downtime using the following this proce...

My friend just set up his router on dyndns.org so it updates the site when his wan ip address changes, this was a feature on his router. How would I do this on my cisco 800 series, how do I map this so the router updates dyndns ?thanksCarlos

HiI'd like to setup three vmware instllations on one host and I'd like each of those vm-hosts to be in a separate vlan. Could some one please tell me how I could do that on my cisco 3548 switch please given that the physical vmware host server only h...

Can someboady help me to know the low end Switch that can be configured for VPN, Packet Filtering etc... within a switch itself?Suresh

Hi Expert!I need to Implement Cisco.Secure.ACS.v3.2.in my Network;i need a technical link the Describe how to configure and Administer this ACS;Also what the configuration be on the decices(switches;routers)?aaa new-model???10xs

We have the n/w of 10.70.0.0/16 at place 'A' and having n/w of 172.16.30.0/24 at place 'B'. we have move some PCs from place 'B' to place 'A', the IP of the shifted PC would remain unchanged i.e. 172.16.30.x/24. I have created VLAN for 172.16.30.x/24...

Hello,after weeks of reading about jumbo frames, I change the value of mtu on my switches to 9000 catalyst 3750.I have 2 location MAN connected by fiber channel. 4 swith cat3750 10/100/1000 on each site. Many of our server have giga nic, connected to...

Hi,I am slightly confused with the default load balancing method used by CEF (Per Destination load balancing).I have 2 links and i would like to know how the router decides to use the links for a flow. I have been having trouble with 2 links which ar...

Hello,I'd like to set up Policy Based Routing on 3550/3750 platform, but a bit I'm affraid of CPU load. Is it SW o HW based? What is the ammount of bandwidth it is able to deal with?Thanks. Honza Klicka

Hi,I?ve got 4x 3560 L2/L3 Switches and one subnet 192.168.1.0\24. The DHCP server will assign IP address to the Clients. The 3560 will be doing Layer 3 routing between it?s gigabit links using OSPF. IP helper address obviously pointing to the DHCP se...

If I use the dialler load threshold 64 command and ppp multilink command on my BRI interface, will this use the second 64k channel once the threshold is reached ?thanks