Solved: Number of line in SHOW COMMAND

mcardell · ‎03-11-2003

Hi All,

a silly question....

What is the command to set the number of line displayed when you type a SHOW COMMAND.

I have to take the show tech from some routers and I need to have the show output in just one go.

I have used this command before, but I do not remember.

Thanks

Matteo

rwiesmann · ‎03-11-2003

Hi Matteo

If i understand you correct you mean the "terminal lenght (#of lines)" command.

If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.

Hope that helps you

Roger

rwiesmann · ‎03-11-2003

Hi Matteo

If i understand you correct you mean the "terminal lenght (#of lines)" command.

If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.

Hope that helps you

Roger