I would like to enquire whether my legacy (1600/2500 series) routers' e0 ports (as the default gateways) on numerous site LANs with last-resort routes to new 3rd-party WAN routers, can be used to offer e0 in-out QoS? I am looking for some way to prioritise or throttle traffic before handing it to the 3rd-party WAN using my existing kit. Thanks in advance!
Hi - many thanks for the reply. My 1601's run 12.01(T), the 2502's & 2516's 11.01 - what would you recommend? - I realise I will have to upgrade them IF (the big IF) this 1-legged method stands a chance of working. I am trying to devote testing time to this proposal, but am also in the midst of a major roll-out, hence this forum!
It is depend on QoS policy you want to apply and the nature of your traffic pattern. For myself, I normally set up QoS on the WAN with out going traffic since it is the most effective way to protect my critical application running smoothly on the expensive link like WAN.
The way to accomplish are
- Classify your traffic with precedence or DSCP bit
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...