I'm trying to find out the implications of setting the switch ports to auto when they are connected to Gig NICs. Since Gig doesn't support half-duplex are there issues with the NIC hard set to 1000/full and the switch port to auto, like there would be with 10/100 Ethernet?
I don't think any problem with NIC card set to 1000/full and switch port to auto. Only if you connect to other catalyst 6500 switch and set the configuration like above, then these switches cann't autonegotiate.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...