cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
211
Views
0
Helpful
1
Replies

10 gig xceiver in Sup V 10Ge Sup Engine

chrish
Level 1
Level 1

I am using an X2-10GB-LR 10 gigabit singlemode xceiver in a Sup V 10GE engine. I am getting low levels across my link. I would like to know if there is any means of optimizing the optics. Via software or otherwise. I have verified that I am transmitting at a level well within the Cisco documented acceptable range, but it would be very helpful if I could tweak it to be as close to the max level as possible.

Presently I cannot find where I could do that or any documentation that supports the ability to do that.

Thanks in advance

1 Reply 1
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco