11-28-2003 02:18 AM - edited 03-02-2019 12:01 PM
I have a 3620 running 12.0(5)T1 with a NM-1E2W installled in slot 0. When trying to configure the ethernet port to operate at full-duplex the router excepts the command. However, I continue to receive error messages indicating the port is not running at full-duplex, plus the collisions still occur. I can not find a bug report for this problem and I can not find any other documentation where others have has this issue. Can anyone help?
11-28-2003 03:45 AM
Pls check at the switch side.
If it is set auto, configure to force Full-duplex.
11-28-2003 04:55 AM
The switch was configured for 10/full and The router's ethernet interface was configured for full-duplex, However, I was receiving collision error messages, so i had to revert back to half-duplex.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide