Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

10BaseT Ethernet Full-duplex

I have a 3620 running 12.0(5)T1 with a NM-1E2W installled in slot 0. When trying to configure the ethernet port to operate at full-duplex the router excepts the command. However, I continue to receive error messages indicating the port is not running at full-duplex, plus the collisions still occur. I can not find a bug report for this problem and I can not find any other documentation where others have has this issue. Can anyone help?

2 REPLIES
New Member

Re: 10BaseT Ethernet Full-duplex

Pls check at the switch side.

If it is set auto, configure to force Full-duplex.

New Member

Re: 10BaseT Ethernet Full-duplex

The switch was configured for 10/full and The router's ethernet interface was configured for full-duplex, However, I was receiving collision error messages, so i had to revert back to half-duplex.

208
Views
0
Helpful
2
Replies