11501: management port stops responding

[kempstonfj]

I have two 11501 content switches configured in chassis redundancy mode and I've found that there are several periods each day at apparently random intervals and lasting a few minutes when one or other of the switches stops responding to an inbound telnet connection to its ethernet management port. A few minutes later and it works again.

Any ideas / suggestions about the cause of this would be much appreciated.

Regards, Mike.

[#2]

check out the speed and duplex settings, u can also check out the following link on configuring redundancy :

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a008029b1da.html

hope this helps.