Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1600 Router does not show T1 configuration

I have a configuration with two 1600 routers connected witha T1 line. I am passing voice and data through this line.

The funny thing is that the system is working(some problems which rarely causes voice distortion) but show running-config command does not show the T1 configuration at all. How can that be? How can the system work and not show the existence of the T1 equipment?

Another similar connection shows the T1 configuration.

"interface Ethernet0

ip address 150.137.133.14 255.255.255.0

!

interface Serial0

description T1 (HCGS200933001MB) from EDS-2722 to EDS-2741

ip unnumbered Ethernet0

"

Any explanation? Can this missing configuration cause the problems I am experiencing?

2 REPLIES
New Member

Re: 1600 Router does not show T1 configuration

if your settings are all default then nothing will show up in he configs.

If you make a change (timeslots, encapsulation, etc.) it should appear.

hth

BT

New Member

Re: 1600 Router does not show T1 configuration

Sh service-module

97
Views
5
Helpful
2
Replies
CreatePlease to create content